Et voila les explications pour monter les hummers mais en anglais......
Je tenterais de traduire plus tard.
How to realize it:
1)buy a land speeder...tiphoon is also good (i'm just making it)
2)buy these code to GW mail order :
2X 102791 small wheels
2X 102731 large wheels
2X LG215/E armor upgrade track guard 1
2X LG215/C armor upgrade track guard 1
1X 9947010105303 whirlwind scanner
1X 9947010105305 whirlwind rocket support arm
3)buy a 3mm wooden staff
4)looking the photo's bend the track trying to adapt it to the bottom of the land speeder
5)make two notch on the rocket support arm to adapt it to the bottom of the land speeder
6)cut off the rear wings
7)cut the bumper like the photo, follow the arrow for the rear cut (no cuts are shown in the photo sorry)
Build normally the land speeder.
And now the hard work begin...
Cut an axe 55mm long from the wooden staff for the anterior axle and plug in the small wheels.
Stick the axle like in photo,it will be necessary put a 2-3 mm lining between the bottom of the L.S.,
i make it after the photo that's the way they aren't in.
The rear track make no problem for assembling,the front are more nasty.
The left fit perfectly on the sensor support in front of the pilot,
for the right try to fit it to the side of the L.S.,light file a corner in the internal part and stick it
(you can make little supports with pins or other ).
Enlarge the large wheels internal hole to fit with rocket arm e fix it to the bottom of the L.S.
At this point the model is finished, put various accessory on it, the tank sprue is perfect,
the rocket is very cool,dont you think?
I just cut the front sensor and i put an heavy bolter instead.
Good job!!
I hope my instructions were more clear than my english, for more write me.
Send me photo's of your job.
I take the idea from a picture on a White Dwarf number but the making is one's own work.
Andrea
scossa@inwind.it
Accueil 
Rechercher 
S'enregistrer 
Connexion 
Sujet: Le projet Hummer 
